Archives for June 2017

Camaro DRL Install

New DRL InstallNew DRL InstallNew DRL InstallNew DRL InstallNew DRL InstallFinally got around to installing the new DRL’s that I bought for the Camaro. I’ve been wanting to do this for over a year and now I wish I’d done it sooner. The pics really don’t do it justice. The stock DRL’s looked yellow compared to the white light of the headlights. It’s hard to tell from the above pics, but there was a huge difference. You can also see the difference from the stock bulbs and the replacement bright LED’s.

New DRL InstallThe install was very easy. Six screws to release the fender liner so it can be moved out of the way for easy access to the light assembly. You don’t have to remove the wheels, but I did because I needed more access to install the last rivet that was part of the splitter install. I knew that I’d eventually replace the DRL’s, so I waited install the last 2 rivets so I wouldn’t be doing this twice. I thought it was going to be a lot harder than it really was.

Splitter InstallSplitter InstallAs you can see from the pics, the last 2 rivets were needed to pull the edges of the splitter against the fascia. I really shouldn’t have driven it as long as I did without these rivets. But they installed easily and really gave it a nice, finished look.

New DRL InstallNew DRL InstallIn the pic on the left, the drivers side DRL has been replaced, but not the passenger side. Again, the pics don’t do it justice, but you can tell that there’s a difference. The pic on the right was taken after both DRL’s were replaced. Now they match the white brightness of the headlights and look so much better. Whole project only took an hour or so. Again, you don’t have to remove the front wheels, but I did for easier access to install the last 2 rivets for the splitter. Happy with the results.

Ruby’s Getting Some New Lamps

Ruby’s Getting Some New Lamps

I’ve been disappointed with the fog lamps on the Camaro since we’ve had it. They look yellow compared to the angel eyes and the halos. So, after putting it off for a year and a half, I ordered the bulbs to correct the issue. Alla Lighting High Power 4014 54-SMD Xtremely Super Bright 6000K Xenon White LED. Best part is that I got a really good deal on them with my Amazon Prime. Looks like a new weekend project. You wouldn’t think that changing a bulb would be that big of a deal, however, to get to the fog lamp assembly, you have to remove the fender liners. I’m sure that cussing will be involved, but I’m anxious to get them changed. I’ll post some before and after photos.