Category: Custom Diecast

  • Sneak Peek At Our Latest Custom

    Just a sneak peek at our latest custom. I’ve been wanting to do this one for a while, just had to wait until I found an extra hanging on the pegs. I don’t have anything major planned for this one, no rust, no weathering, just a new paint job and a few extras. I’ve already…

  • Custom Hot Wheels VW T2 Part VII Finale

    I finally finished the custom Hot Wheels VW T2 Bus. I’m not totally satisfied with the end results, but overall, it’s not that bad. This custom took a lot longer than I thought it would. I ended up restarting 3 times during the process. I just couldn’t get the look that I was going for…

  • Custom Hot Wheels VW T2 Part VI

    So, I’d say that the Custom Bus is about 95% complete now. The headlights still need some attention, I need to make a custom tarp roll, then I need to create the base (1/64 scale die cast holder) with a bit of scenery. But the bus itself is pretty much complete. This has been a…

  • Custom Hot Wheels VW T2 Part V

    I did a little back tracking on the custom VW Bus this week. I wasn’t pleased with the custom tail gate or the rails for the tarp/cover. The rails for the tarp were a bit out of scale (I used large paperclips), so I removed them and made new ones out of small paperclips. The…

  • Custom Hot Wheels VW T2 Part IV

    Had some time today to work on the Custom VW Bus. I wanted to add supports to the new rails for a tarp or some kind of cover. 3 large paperclips seemed to fit the bill perfectly. For consistency, I soldered the ends of the paperclips together before I bent them. This ensured that the…